Citrix 1Y0-250 Exam Syllabus Topics:
| Section | Objectives |
|---|---|
| Topic 1: Basic Networking | - Networking fundamentals
|
| Topic 2: Unified Gateway | - Unified access
|
| Topic 3: Gateway Services Load Balancing | - Gateway optimization
|
| Topic 4: End-User Access and Experience | - Remote access
|
| Topic 5: Authentication and Authorization | - Identity integration
|
| Topic 6: SSL Offload and Security | - SSL implementation
|
| Topic 7: Integrating NetScaler with XenApp and XenDesktop | - Citrix integration
|
| Topic 8: Monitoring, Management and Troubleshooting | - Administration
|
| Topic 9: Getting Started | - NetScaler architecture and components
|
| Topic 10: High Availability | - High availability configuration
|
| Topic 11: Access Policies | - Policy configuration
|
| Topic 12: Load Balancing | - Application delivery
|
Citrix Implementing Citrix NetScaler 10 for App and Desktop Solutions Sample Questions:
1. Which two actions should an administrator take to ensure the first NetScaler node configured in a high availability (HA) pair remains the primary node after a second node is added? (Choose two.)
A) Create a Route Monitor to ensure proper synchronization.
B) Enable HA Sync before adding the second node.
C) Set Stay Primary on the first node.
D) Configure Stay Secondary on the second node.
E) Ensure that INC mode is enabled during creation of the HA pair.
2. Scenario: An administrator notices that each time the secondary node of a high availability (HA) pair is restarted, the primary node shifts to a non-working state.
The administrator runs a command and collects the information displayed below:
1) Node ID. 0
IP: 172.31.250.10
Node StatE. NOT UP
Master StatE. Secondary
INC StatE. DISABLED
Sync StatE. DISABLED
Propagation: ENABLED Enabled Interfaces : 1/5 1/1 1/2 1/4 0/1 Disabled Interfaces : 1/3 HA MON ON Interfaces : 1/4 1/1 0/1 Interfaces on which heartbeats are not seen : 1/4 1/1 1/2 1/5 0/1 Interfaces causing Partial FailurE. 1/4 SSL Card Status: UP Hello Interval: 200 msecs Dead Interval: 3 secs Node in this Master State for: 0:0:0:35 (days:hrs:min:sec)
2) Node ID. 1 IP: 172.31.250.20 Node StatE. UNKNOWN/DOWN Master StatE. UNKNOWN INC StatE. UNKNOWN Sync StatE. UNKNOWN Propagation: UNKNOWN Enabled Interfaces : UNKNOWN Disabled Interfaces : UNKNOWN HA MON ON Interfaces : UNKNOWN SSL Card Status: UNKNOWN
What could be the cause of this issue?
A) Synchronization is disabled.
B) The Hello Interval is set too high.
C) One of the HA Monitoring interfaces is failing.
D) One of the interfaces is disabled.
3. When a user launches a published version of Notepad, the user receives the following error message:
"Cannot connect to the Citrix XenApp server.SSL Error: The proxy denied access to 10; STA393B6A5D1088; 9764757E39D0BEBB0BFC66E9EE146FF4 port 1494."
What could be the cause of this error message?
A) Web Interface CANNOT reach the XenApp server.
B) NetScaler Gateway CANNOT reach the XenApp server.
C) Web Interface CANNOT reach the XML broker.
D) NetScaler Gateway CANNOT reach the Secure Ticket Authority server.
4. Scenario: A virtual server has been configured in the Content Switching node to provide multiple Web services using the full website path location. This website contains details that can only be displayed using a specific Web browser such as Internet Explorer.
Which two actions must an administrator perform to ensure that users are informed of the browser requirements? (Choose two.)
A) Configure a redirect URL to redirect users to a website that informs them of the browser requirements.
B) Configure Advanced Expression policies to determine the type of browser used.
C) Create a backup server to display a website that informs users of the browser requirements.
D) Configure a default policy to redirect users to a website that informs them of the browser requirements.
5. Scenario: An administrator must implement NetScaler Gateway. The solution must allow users to be able to change their Active Directory password from the NetScaler Gateway logon page.
Which two actions must the administrator perform to meet the requirements of this scenario? (Choose two.)
A) Configure LDAP authentication.
B) Add a RADIUS authentication server.
C) Configure LDAPS authentication.
D) Enable the 'Allow password change' option for the LDAP authentication server.
Solutions:
| Question # 1 Answer: C,D | Question # 2 Answer: C | Question # 3 Answer: D | Question # 4 Answer: B,D | Question # 5 Answer: C,D |
1367 Customer Reviews
Quality and ValueITCertKing Practice Exams are written to the highest standards of technical accuracy, using only certified subject matter experts and published authors for development - no all study materials.
Tested and ApprovedWe are committed to the process of vendor and third party approvals. We believe professionals and executives alike deserve the confidence of quality coverage these authorizations provide.
Easy to PassIf you prepare for the exams using our ITCertKing testing engine, It is easy to succeed for all certifications in the first attempt. You don't have to deal with all dumps or any free torrent / rapidshare all stuff.
Try Before BuyITCertKing offers free demo of each product. You can check out the interface, question quality and usability of our practice exams before you decide to buy.
